Due to the tiny gap between the end mill and the tool holder, the tool may vibrate during the machining process. Vibration will cause uneven cutting of the circumferential edge of the end mill, and the cutting and spreading amount will be larger than the original value, which will affect the machining accuracy and tool life. But when the processed groove width is too small, the tool can also be purposefully vibrated, and the required groove width can be obtained by increasing the cutting and expanding amount. In this case, the maximum amplitude of the end mill should be limited to less than 0.02mm , Otherwise stable cutting cannot be performed. In normal processing, the vibration of the end mill is as small as possible.
When tool vibration occurs, you should consider reducing the cutting speed and feed rate. If both have been reduced by 40% and there is still greater vibration, you should consider reducing the amount of tooling.
If the processing system resonates, it may be caused by factors such as excessive cutting speed, low feed rate, insufficient tool system rigidity, insufficient workpiece clamping force, workpiece shape or workpiece clamping method, etc. At this time, adjustments should be taken to cut Measures such as dosage, increase the rigidity of the tool system, and increase the feed rate





