The collision of the 3d milling machine kit will affect the performance of the machine tool and the process of the machining task. When a collision accident occurs, the workpiece will be scrapped, and the spindle will be affected, which will seriously endanger the service life of the machining center. When a novice is operating a machine, it is difficult to avoid a collision. However, if we use the correct processing methods, we can avoid collision accidents as much as possible. Admiral from the side, is it really difficult to prevent collisions? Of course not. In fact, many 3d milling machine kits have their own anti-collision machine function when they are designed. Let’s explore for you. Let’s take a look at the anti-collision machine function that comes with the 3d milling machine kit. What the hell is going on.
In the current 3d milling machine kit operations, basically all have the "single-stage fulfillment"-SigleBlock function. This button can determine whether the operator has the opportunity to stop when an error occurs, and "start by cycle" in the processing order Before, we must first determine whether the machine's next actions are exactly the same as our expectations. If we are not sure that the machine will perform aesthetic actions next, then it is best not to press the button of "Cycle Start" to avoid In the case of uncertain processing procedures, unnecessary processing waste is caused.
The "single-stage performance" function is an important part of this rule. In the case of program changes, tool replacement, coordinate system changes, etc., this function will effectively reduce the collision results caused by mistakes.
The "single-stage execution" function is a very important part of this rule. Under the conditions of program changes, tool replacement, and coordinate system changes, this function will effectively reduce the collision accident caused by mistakes. In daily processing, after the programmer has written the program, the operator needs to perform the next operation according to the tool list and the program list.
Programmers need to imitate the processing conditions as early as possible and find some possible risks in the processing as early as possible. After obtaining the post-processing program, they also need to check again. Unauthorized processing procedures for operators will affect mutual trust, cause psychological pressure on both sides, and cannot effectively avoid the occurrence of collision accidents. Secondly, continuous training of operators and engineering personnel to minimize the occurrence of collision accidents is something that enterprises need to pay attention to.
