1) When the workpiece is dragging the table, you must pay attention to the verticality, drag one side to level, and then drag the vertical side.
2) When the workpiece is scored, it must be scored twice for verification.
3) After scoring the middle and hitting the number, check the middle position according to the outline size and the size on the part drawing provided in the program sheet.
4) All workpieces must be centered by the centering method, and the zero position must be centered by the centering method on the side of the workpiece and then moved to the side. The margins on both sides must be consistent. If unilateral access is required under special circumstances, it must be confirmed by the production team again before it can be passed. After taking the count on one side, remember to compensate the radius of the center bar.
5) The zero input of the workpiece center must be the same as the three-axis center of the workstation computer diagram.
