Many vertical machining centers have been processed for a long time. If they are not maintained for a long time, the residual machining scraps in the machine tool will cause large and small failures of the machine tool. For example, the accuracy of our guide rail screws will be affected. . . When it comes to maintenance, many users say there is no way to start. Some users may even ask: Does the machine tool need to be maintained? Do a good job in vertical machining center maintenance to maintain the best machining accuracy of the machine and extend the service life of the machine.
1. As shown in the figure below, the machine tool processing waste should be cleaned up in time
2. Check whether the oil pump is working normally and whether the oil volume is within the required range
3. Air source treatment. If there is too much water in the air, manually press and hold the drain in the direction indicated by the arrow in the figure below.
four. The cutting oil must ensure that all parts of the machine tool do not rust, and the cutting fluid is recommended to choose the following specifications
5. Open the tool magazine cover and regularly clean the cutter head and claws to ensure normal operation.
6. Keep the internal control of the spindle clean. Wipe the taper hole with a clean cloth regularly. It is strictly forbidden to blow air against the inner hole of the spindle with an air gun.
7. Regularly clean the oil and dust in the electric control cabinet, check whether the cooling fan is operating normally, and cut off the main power supply of the machine tool when cleaning.
8. Regularly open the guard to clean up the waste inside to avoid excessive waste from jamming the screw or guide rail and affecting the accuracy of the machine tool.
9. The appearance of the machine tool should not have oil and dust on the sheet metal, so as to avoid oil and too much dust to affect the machine tool accessories.
10. List of common alarms of the drive
