old way:
That is the most basic method, COPY SURFACE, which is the most talked about method in a Taiwanese professor's textbook; it is also the most earthy method! If you use this method to divide some complex molds, it will be too troublesome!
Cutting method:
Many times, when we parted the parting surface, we found that it was inseparable and there were many green lines and red dots. At this time, we can choose the cutting method. The specific method is: directly copy the parting surface Extend to the direction of the front mold to the thickness of the front mold core, close it to form the front mold core, and then make a body as the rear mold core, cut off the front mold part with the parting die, and then use the reference part to directly CUTOUT the rear mold core cavity come; picture
Of course, for the situation in 2, the precision modification method can also be used to solve it. Adjusting the precision properly can also solve some situations. It is also possible to adjust the mold precision and product precision in the design process to keep the same, (preferably in CONFIG ) directly set the product accuracy and mold accuracy to be consistent;
Hole filling method:
When making the surface, do not go to COPY SURFACE (recommended), and directly make some relatively simple curved surfaces to block the holes. Sometimes the curved surface is not easy to make, and you can directly grow a 0.01mm thick solid. , and then some relatively simple large parting surfaces can be separated;
Skirt method:
For most of the shell products, it is recommended to use the skirt as the parting surface, which is not only easy to part the mold but also makes the parting surface more beautiful;
Parting surface method in the product:
Sometimes it is a very strange thing. It is easier to separate the products that cannot be separated by directly making parting surfaces in the mold section. Xiao Ke knows that many masters use this method to divide the mold;
Volume method:
Sometimes it can also be done by directly making volume blocks, including making finished volume blocks and making several volume blocks at will before dividing and merging the volume blocks;
Packing method:
At some point, when the main parting surface is used for parting, there will be inseparable situations, but don't give up easily, try another parting surface (such as inserts, pins or sliders) to divide it. Surprised; picture
9 Amendments to the Product Act:
This method is more useful for some image files converted by third-party software and some products with poor surface quality. You can make appropriate modifications to some parts of the product, but be careful not to change the product arbitrarily Appearance and functional parts. It is also possible to make a new part, using data sharing to insert the physical surface of the original product. The disadvantage is that the mold file cannot be reproduced and changed when the product design is changed;
10 Scalper method:
There is no way to do this, but it is absolutely feasible, that is, for some products with poor product modeling quality and simple mold structure, it is better to do it honestly than try all kinds of methods to find the best way to split the mold. Scalpers, each mold part is directly made by using the curved surface on the product one by one. Of course, such things are really annoying, but once you encounter them and your computer is not very good, the method can still bring you convenience. of
!
