How to recover forgotten password?
Can only be initialized.
(Robot upside down installer), how to install it?
Inform the robot that the fixing method is the same as that of the seat mounting, but the robot needs to be placed in the hoisting position by itself.
How to correctly connect the new control cabinet to the power supply
Power on?
Look carefully at the nameplate on the lower side of the control cabinet
Connect the power supply relay after applying the power supply voltage
When can I use QUICK MASTER to restore the zero point?
When the robot loses its zero position due to electrical or software failure, QUICK MASTERING can be used.
Can't edit the program on the teach pendant?
Turn on the ON/OF switch in the upper left corner of the teaching device.
Does the robot choose RSR start mode to restart and then change back to PNS start?
Check that the U signal allocation in the MENU-I/O menu is duplicated (mostly U17 and UI6 are allocated to the same signal port).
What if there is no file option for the main purchase order of the robot?
Select the FCTN menu-simple/full screen switching function.
What is the maximum number of additional axes that can be added to the robot?
Currently the most robot controllers
It can control 40 axes and can be divided into multiple groups.
What is the difference between the robot motion command CNT and FINE? The end point type is different. CNT is excessive point control, which makes the point motion more consistent; FINE is to reach the position point accurately.
How to confirm the accuracy of TCP? The TCP switch tool coordinate system number, rotate the robot fingertip around the reference point in ×, Y, Z directions, and observe the distance between the fingertip and the reference point: the smaller the value, the better.
Can the teach pendant and the teach pendant cable of different robots be mixed? If the robot's control cabinet models are the same, they can be mixed.
How to check the time of the clock command?
The clock register can be displayed in PRG TIMER in the status bar.
Will the robot R register be reset automatically when the controller is restarted?
The data in the robot R register will not be automatically cleared when the controller is restarted. It needs to be cleared manually or assigned to 0 by instructions in the program.
How to maintain a constant speed while the robot is running?
Except for the start and stop segments, the motion command can be guaranteed in other intervals
Keep moving at a constant speed.
