Sep 24, 2021 Leave a message

CNC Programming Of Milling Machining Center—Transmission Between CNC And PC


To put it simply, milling Machining Center is a general milling machine with a CNC system. The data transmission between the machining center and the PC is an important part of the work of the machining center. The following editor takes FANUC system as an example to introduce the operation method of transmission between machining center and PC.


DNC processing is used in machining centers. Generally, when processing molds, because the processing program is too long and the CNC memory is not enough, it is a way to connect a personal computer and transmission software to the CNC's RS232 interface to transfer the program while processing.


If the CF card is used for DNC processing, there is no need to set the parameters. The operation method is as follows:


1. Set the I/O channel to 4;


2. Choose DNC mode;


3. Select the memory card list display screen, enter the number of the program to be run, and press the soft key DNC setting to select the program to be run;


(Place the operation panel on the DNC transmission and press program and a line of options will appear at the bottom, and then press the memory card to select the program to be selected.)


4. Press the cycle start switch to start DNC transmission operation.


Operation method:


1. Connect the computer CAXA software and the machine tool with the RS232 interface cable.


2. Use CAXA to make a trajectory, generate "G code", and save it.


3. Open the CNC transmission software and find the generated TXT file.


4. Click upload first, and then click read on the machine tool.


5. OK


The common CF card on the market can be


CF card transfer is the most convenient, no need to change the parameters. But make sure that the key switch is turned on in advance. Directly press the Progrm key to find the program, operate-select the device-select the card-press the input file-then enter the file name F to retrieve (you can also enter the serial number O to retrieve)-and then press execute.


What should I do if FANUC machining center alarms during program transmission?


First: The baud rate, data bit, parity, stop bit and other data of CNC and PC must be consistent;


Second: The written program must be standardized, and there should be no unnecessary spaces, brackets and other characters that cannot be recognized by the system in each sentence of the program, especially there may be a space at the end of each sentence of the program. Check the written program carefully. If an alarm occurs during transmission, it is likely that the written program does not meet the specifications.


Third: Check if there is any problem with the data cable. If it is soldered by yourself, check if there is a problem with the data transmission and reception cable.


Send Inquiry

whatsapp

skype

E-mail

Inquiry