First of all, you must determine the workpiece clamping plan, depending on whether you use a vice or a chuck, or directly put it on the table with a pressure plate, or have tooling. Generally, the plane must be determined first, and then straightened. Three-point positioning, the top surface of the calibration must have a margin. Then align the x-axis of the workpiece version on a straight line to facilitate the establishment of a coordinate system. Find the center of a circular workpiece directly, touch the xy axis of the workpiece to the center of each two points, and directly use the edge finder or the dial indicator to circle the circle for finishing.
When processing different parts, you can use a dial indicator to correct the processing accuracy. For example, when processing round parts, you can use square equipment to correct. Manually adjust to the workpiece near the spindle, which can be divided into spindle and The axis line, use the relevant instrument to adjust the magnetic meter seat to the end surface of the main shaft, and cooperate with the installed meter sub-meter head, the CNC double column gantry machining center can make the cylindrical surface in a vertical state during the processing of the workpiece.
At the same time of calibration, you can use the instrument to calibrate the processing bearing separately to achieve the X-axis calibration. You can adjust the X-axis processing coordinates accurately during processing, so that the workpiece can be effectively processed. It is not easy to calibrate at the same time , You can find the common point between the dial indicator X2 and X1, and the Y-axis can be corrected in the same way.
In addition, you can use the lever to cooperate with the instrument to calibrate. You can find the position correction with the edge finder. For processing anti-kick workpieces, you need to make a slight correction in the same direction. The two sides of the correction can achieve the smallest difference between the values to ensure the processed parts. Accuracy.
Different workpieces are processed with different angles. If the angle deviation is large, it needs to be corrected. X and Y share the use of lever and dial indicator for correction. The origin can also be defined by scribing. CNC double column machining center uses dial indicator to measure , Just adjust to the origin that needs to be processed, but at the same time, you need to pay attention to the hand wheel to prevent it from being touched during processing, which will cause damage to the tool tip and workpiece.




