Jan 10, 2024 Leave a message

Extrusion Plastic Pipe Mold, Common Faults And Solutions!

 

⑴ Material leakage at the connection between the mold and the barrel:


The reasons are:

①The processing accuracy of the connection and mating of the two parts is low. ⒈The mating surface is rough; ⒉The vertical accuracy between the mating surface and the center line of the mold body is low. ②The two contact surfaces of the connection are not clean and contain foreign matter.

Troubleshooting methods include:

① Re-fit the mold body's joint surface, ⒈ Improve the smoothness of the mating surface; ⒉ Ensure the perpendicularity between the mating surface and the center line of the mold body. ②Inspect and remove dirt and foreign matter on both contact surfaces.

⑵Difficulty in disassembly:


The reasons are:

① There is overflow between the assembled parts in the mold body. ②There should be no burrs on all mating parts before assembly. ③The solid connecting bolts are not coated with silicone oil before assembly. ④Deformation of parts.

Troubleshooting methods include:

①Remanufacture to improve the accuracy of matching parts. ②Clean the parts before assembly. ③Apply high-temperature resistant silicone oil before assembling the bolts. ④ Replacement parts should be made of high temperature resistant and small deformation steel.

⑶The screw joint is easy to break:


The reasons are:

①Improper use method. ②The selection of manufacturing materials is unreasonable.

Troubleshooting methods include:

① When adjusting the die gap adjustment screw, first loosen the screw on the small side of the die gap, and then adjust and tighten the screw on the large side of the die gap. ② If necessary, it should be made of 45 steel and heat treated to a hardness of 40~45HRC.

⑷Deformation of parts in the mold:


The reasons are:

① Improper disassembly method. ②Squeezed by heavy objects during storage. ③The selection of manufacturing materials is unreasonable.

Troubleshooting methods include:

① Do not hit with a heavy hammer during disassembly and installation. ②No heavy objects are allowed to be placed on the mold body during storage. ③Made of high temperature resistant, small deformation steel.

⑸The product quality is unstable and the adjustment operation is difficult:


The reasons include: low manufacturing precision of parts in the mold, improper selection of mutual matching accuracy, and rough mating surfaces.

Troubleshooting methods include:

The mold is remanufactured, and the fit between parts should be H7/h6; the surface roughness Ra of the mating surface should be no greater than 1.25um; the surface roughness Ra of the melt flow channel should be no greater than 0.25um; ensure the vertical accuracy of the mating surface and the centerline of the part .

⑹ The flow rate of the extruded material from the die is unstable:


The reasons are:

①The temperature of various parts of the mold body is uneven and the error is large. ②The gap between the die and the mandrel is uneven. ③ There is foreign matter blocking the mold. ④Plasticizing system problems (bridging of raw materials in the hopper; unstable plasticizing temperature, large fluctuations in temperature difference, excessive matching gap between the screw and barrel; unstable screw speed, etc.).

Troubleshooting methods include:

① Check the heater and replace damaged parts; make sure the heating jacket is in good contact with the mold. ②Adjust the gap between the die and the mandrel. ③Disassemble the mold and remove foreign matter. ④Inspect the plasticizing system and troubleshoot.

 

 

Send Inquiry

whatsapp

skype

E-mail

Inquiry