Application of cutting tools in high-speed milling
High-speed milling (HSM) uses high feed rates and small cutting parameters. Tool vibration directly affects the quality of the machined surface. Therefore, it is very important to maintain uniform cutting force and avoid tool vibration during high-speed milling finishing.
1) Good coaxiality is conducive to uniform load distribution on the cutting edge;
2) Larger cutting edge overlap is beneficial to obtain uniform cutting force characteristics (larger helix angle and groove number);
3) Short cutting length is conducive to obtaining better rigidity;
4) The cross-section of the core is the best, and the stress concentration at the notch is the smallest.
When high-speed milling is used to process high-hardness materials, the load on the cutting edge will increase, which will generate more frictional heat, and the clearance angle of the tool must be reduced. When the material is very hard and the tool material is very brittle, it may even lead to a negative bevel.
If the machining accuracy is very high, as a basic condition, the size of the finishing tool should meet strict tolerance requirements.
Material and coating:
The tool material must be harder than the material to be machined. The harder the tool material, the smaller the tool wear and the longer the tool life.
During the cutting process, the local temperature is very high, and it is necessary to ensure that the tool material has oxidation resistance. Large thermal load fluctuations and the requirements for the oxidation resistance of tool materials make it necessary to finally coat fine-grained cemented carbide tools. For example, the use of TiN, TiCN and TiAlCN can better exert the performance of high-speed machining. Using nano-layer structure, CBN and PKD, higher performance can also be achieved.
02
Application of Tool Holder in High Speed Milling
Due to the high spindle speed required in high-speed milling, it is best to use HSK-A and HSK-E tool holder systems.
Since the tool holder flange is installed on the spindle head, the tool holder has a clear mechanical support in the Z direction, so it will not enter the spindle due to the increase of centrifugal force at higher speeds.
Dynamic balance and coaxiality
To achieve stable high-speed milling, it is important to dynamically balance the tool and tool holder device and check its coaxiality according to the requirements. It is also necessary to consider the rotational speed limit related to the dynamic balance quality.
A rotating tool system with poor dynamic balance or poor coaxiality will lead to:
• Very poor surface quality
• Very low tool life
• Poor processing stability and safety
• May damage the milling spindle
Unbalance and deviation from the ideal coaxiality caused by sudden changes in the processing process, the result can be seen very clearly in the following schematic diagram:
Coaxiality deviation is small, and the theoretical roughness is small
Larger deviation of coaxiality, larger theoretical roughness
Dynamic balance has an important influence on the dynamic performance of the entire rotating system. When unbalanced, there is an eccentric object rotating. This eccentric object can induce centrifugal force, which increases squarely with the increase in speed. Therefore, the unbalance of the tool holder device in high-speed machining has particularly obvious adverse consequences. It is recommended to use the interface HSK-E.
Application of tool clamping technology for high-speed milling:
• Chuck and nut
• Heat shrinkable connection
Since the good damping characteristics of the tool holder with chuck can bring good results to the roughing process, it can achieve extremely high rigidity and repeatability, which is essential to obtain a perfect workpiece surface.
The shrinkable tool holder can obtain very accurate coaxiality (deviation less than 0.003mm) and transmit large torque.
Design structure of various reduced diameter tool holders:
The transmitted torque depends on the design structure of the clamping device. The design structure is different, they may be very different.




