Natural disasters that humans cannot resist, the disrepair of energy systems, or working environments with potential safety hazards, etc., may interrupt normal production and cause losses to companies and individuals.
To reduce this loss, in addition to maintaining the factory's power facilities on time, we must also preventively eliminate safety hazards in the working environment.
For those in the working environment, don’t be afraid of trouble by wearing protective equipment as required. Training related professional knowledge, such as basic firefighting and first aid knowledge. In short, safety comes first.
The equipment and supporting facilities used must be maintained as required to prevent problems before they occur.
The machine itself will also have automatic detection functions, such as power phase loss, motor overheating and other key preventive alarms. For specific handling methods, please refer to the tips in the operation manual.
After the power is restored, production must continue as usual, and the procedures that were previously interrupted need to be continued at this time.
Although there are many ways to restore the machine to its previous state, re-edit the program, or call a new program. But none of them are safe and simple enough.
In the Haas CNC system, setting No. 36 in the settings page can accomplish this task excellently.
First, set Setting 36 (Program Restart) to on.
Next, highlight the starting line you want to restart.
This may take a short time to scan through the previous program and restore the machine to the state before the highlighted line. If the tool change row is highlighted, the machine may perform a tool change action, first changing to the tool used before the highlighted row, and then changing back to the tool in the highlighted row. This is normal operation, don't panic.
Then, turn on the single section stop mode and switch the coordinate display on the screen to: moving distance. These two steps are highly recommended. Prejudging the movement trajectory of the machine and controlling the machine's operating status in a more timely manner are crucial to production safety.
picture
Finally, close the door and start processing.
picture
It's that simple, no need to modify the program or call a new processing program.
You can leave Setting 36 (Program Restart) on all the time, or only when in use.
The difference between them is: when setting No. 36 is turned off, the control system will not spend time scanning the previous program, nor will it restore to the state before the highlighted line, so you need to decide whether it is worth it based on your actual needs. Take your time and allow the machine to return to the state it was in before the highlighted line.




