(Mold size = product size Lines are deleted in the back mold, and lines that do not belong to the back mold should be deleted.
2. The finished product should follow the principle of centering in the mold, especially if it is symmetrical. If the finished product is not centered, errors are likely to occur when it is processed in the factory.
3. For all pillow position molds, the pillow position must be protected from water. If it is impossible to avoid it, a sprue iron must be added.
4. The distance between finished products is 12-20mm (under special circumstances, 3mm can be used). When entering the water for diving, there should be enough diving position. The distance between the finished product and the CORE is 15-50mm. The distance between the finished product and the CORE is related to the storage degree of the product. , general products can be selected by referring to the empirical values in the table below.
Product thickness (mm) Finished product to CORE edge value (mm)
20 15-20
20—30 20—30
30-40 30-40
﹥40 50
5. The depth of the hidden CORE (internal molding material) is more than 28mm. The thickness of the inner molding material in the front and rear molds is related to the plane projection area of the product. For general products, please refer to the table below and select the empirical value. There should be a distance of 10mm from the CORE material edge to the back needle. Mold expert's personal WeChat: mujuren
The projected area of the product plane is the thickness of the mold material in the front mold A + the depth of the cavity. The thickness of the mold material in the rear mold B + the depth of the cavity.
SP,CM mm Mm
﹤77 25 32
77—116 32 38
116—154 38 50
154—193 44 64
≧193 50 76
The width of the CORE material is generally 5-10mm wider or narrower than the ejector pin. At a minimum, the finished glue position should be within the ejector plate without affecting the ejector pin. The CORE material edge to the mold base edge should generally be 45-80mm.
6. When multiple CAVITY are produced on one inner mold material, the size of the inner mold material shall not exceed 200×200mm.
7. The fillet in the mold frame is generally 10mm. If a precision frame is required, the fillet is 16mm or larger. There is no rounding in the beryllium copper mold.
8. Any plastic water entry position should avoid going straight from the nozzle into the cavity.
9. For mirror-transparent beer plastics (K material, acrylic, PC, etc.), it should be noted that the water flow rate and water inlet position of the cold material well cannot be directly balanced (flush). Generally, it is made into an "S" type to buffer the water inlet, and fan-shaped pouring, so that Avoid gas-level flow clouds on the surface of the finished product.




