Oct 16, 2021 Leave a message

U Drill in The Use Of CNC Vertical Milling Machine Tools


U drill in the use of CNC machine tools


1. U-drills have high requirements on the rigidity of the machine tool and the neutrality of the tool and the workpiece when used. Therefore, the U-drill is suitable for use on high-power, high-rigidity, and high-speed CNC machine tools.

2. When using a U drill, the center blade should be a tough blade, and the peripheral blade should be a sharper blade.

3. When processing different materials, inserts with different geometries should be used. Generally, when the feed is small, the tolerance is small, and the U-drill length-to-diameter ratio is large, the groove-shaped insert with smaller cutting force should be selected. On the contrary, rough machining, large tolerance, U If the length to diameter ratio of the drill is small, the groove-shaped insert with larger cutting force should be selected.

4. When using a U drill, you must consider the spindle power of the machine tool, the stability of the U drill, the pressure and flow of the cutting fluid, and control the chip removal effect of the U drill. Otherwise, the surface roughness and size of the hole will be greatly affected. Accuracy.

5. When clamping the U drill, make sure that the center of the U drill coincides with the center of the workpiece and is perpendicular to the surface of the workpiece.

6. When using U drills, choose suitable cutting parameters according to different parts materials.

7. During the test cutting of the U drill, be sure not to reduce the feed rate or reduce the speed at will due to caution and fear, which may damage the U drill blade or damage the U drill.

8. When using a U drill for machining, when the blade is worn or damaged, carefully analyze the cause and replace the blade with better toughness or more wear-resistant.


9. When using U drills to process stepped holes, you must first process the large holes and then process the small holes.

10. When using the U drill, pay attention that the cutting fluid must have enough pressure to flush out the chips.

11. The blades used in the center and the edge of the U drill are different, and must not be misused, otherwise the U drill shaft will be damaged.

12. When using U drills to drill holes, you can use workpiece rotation, tool rotation, and simultaneous rotation of the tool and workpiece. However, when the tool moves in a linear feed mode, the most common method is to use the workpiece rotation method.

13. When machining on a CNC lathe, the performance of the lathe should be considered, and the cutting parameters should be adjusted appropriately. Generally, the speed is reduced and the feed is low.


Send Inquiry

whatsapp

skype

E-mail

Inquiry