Mar 20, 2021 Leave a message

3D Cutter Compensation in Five Axis End Milling with a Flat end mill


In the process of five- axis end milling with a flat- bottomed tool,if the 3D cutter com-

pensation function was adopted, the motion of linear axis control point would be unsteady because

there would be singular solution during solving the radius compensation vector. To provide the precon-dition for solving such problem,it was needed to detect positions where motion mutation will happen.

The reason that the singular point generated during 3D cutter compensation was analyzed based on

building the relationship between coordinates of the cutter contact point and the linear axis control

point. For the singular point , the adjacent points of the singular point and the boundary of the singular area,which were three positions where motion mutation would happen,a detected algorithm was ad-vanced, which was based on calculating the angle between the tool axis vector and the normal vector and observing the symbol of the dominant angle of the tool axis posture. A simulation experiment was performed to verify the correctness and the effectiveness of this algorithm.


Send Inquiry

whatsapp

skype

E-mail

Inquiry