Five-axis end milling of flat-bottomed knives on blades, impellers and spirals
It is widely used in the machining of complex free-form surfaces such as paddles, and has become a research hotspot in five-axis machining in recent years.
In five-axis end milling, using the 3D tool compensation function can make the CNC program independent of the tool radius. When the actual tool radius changes slightly compared to the standard tool radius used in CAM, or the tool radius is slightly reduced due to wear, there is no need to regenerate the tool location file, which greatly improves the processing efficiency and saves processing costs. However, for flat-bottomed knives, when the 3D tool compensation function is applied, if the tool axis vector of the current interpolation point coincides with the surface normal vector, the radius compensation vector cannot be obtained from the general formula and becomes a singular solution, which is in the singular area. , The direction of the radius compensation vector of adjacent interpolation points may change too much, even reaching 180°. In this case, the synchronization of the movement of the tangent contact and the linear axis control point is greatly reduced, which is expressed as: each interpolation cycle The displacement of the inscribed contact is small and basically the same, while the displacement of the linear axis control point will suddenly increase; at the same time, the feed speed of the tangent contact is relatively stable, while the feed speed of the linear axis will undergo abrupt changes.





