⑴ Main machine faults The main machine of a CNC machine tool usually refers to the mechanical, smooth, cooling, chip removal, hydraulic, pneumatic, and protective parts of the CNC machine tool. The main common faults of the host are:
1) Mechanical transmission problems caused by improper use of mechanical components, debugging, operation, etc.
2) Problems caused by the intervention of moving parts such as guide rails and spindles, excessive friction, etc.
3) Problems caused by damage to mechanical parts, poor joints, etc., etc.
The main problems of the main engine are mainly caused by high transmission noise, poor processing accuracy, large running resistance, non-stop action of mechanical parts, damage to mechanical parts, and so on. Poor smoothness, infarction and poor sealing of hydraulic and pneumatic systems are common causes of host failures. Regular maintenance and maintenance of CNC machine tools. It is an important measure to control and eradicate the occurrence of the "three leaks" phenomenon and reduce the local faults of the host.
⑵ Faults in the electrical control system From the types of components used. According to common habits, electrical control system faults are usually divided into two categories: "weak current" faults and "strong current" faults.
The "weak current" part refers to the control part mainly composed of electronic components and integrated circuits in the control system. The weak current part of CNC machine tools includes CNC, PLC, MDI/C RT, servo drive unit, output unit, etc.
"Weak current" faults are divided into hardware faults and software faults. Hardware failures refer to the failures of the above-mentioned local integrated circuit chips, discrete electronic components, connectors, and external connection components. Software faults refer to faults such as germanium and data loss in actions presented under normal hardware conditions. Common ones are. Processing program error, system program and parameter modification or loss, computer calculation error, etc.
"Strong current" part refers to the main circuit in the control system or the relays, contactors, switches, fuses, power transformers, motors, electromagnets, limit switches and other electrical components and their components in the main circuit or high-voltage and high-power circuits. Control circuit. This part of the problem is easier to repair and diagnose, but because it is in a high-voltage, high-current working state, the probability of a problem is higher than that of the "weak current" part. Sufficient attention from maintenance personnel must be aroused. According to the nature of the problem
⑴ Affirmative faults Affirmative faults refer to the faults that the CNC machine tools will inevitably occur if the hardware in the host computer of the control system is damaged or only certain conditions are met. This kind of fault is the most common phenomenon on CNC machine tools, but because it has certain rules, it also brings convenience to maintenance.
Affirmative faults are irrecoverable. Once a fault occurs, the machine tool will not automatically return to normal if it is not stopped for maintenance. But only need to find the basic cause of the problem, and the machine tool can return to normal immediately after the repair is completed. Correct use and careful maintenance are important measures to eradicate or prevent the onset of problems.
⑵ Random failures Random failures are the occasional failures of the index-controlled machine tool during the working process. The cause of such failures is relatively obscure, and it is difficult to find its regularity, so it is often called "soft failure", the cause of random failures It is difficult to analyze and diagnose faults. Generally speaking, the onset of faults is often related to the quality of the components, the setting of parameters, the quality of components, the imperfect software design, the influence of the working environment, and many other factors.





