Numerical control processing is an effective way to solve the problems of multiple parts, small batches, complex shapes, and high precision requirements, and to achieve high-efficiency and automated processing. The cnc machining center 850 has entered our machining workshop as a machine with a wide range of CNC machining applications. Due to the popularity of CNC technology, machining centers are no longer mysterious. CNC machine tools and traditional machine tools are roughly the same in general. The main difference is that the machining center completes all cutting procedures through one clamping and continuous automatic processing. , So the machining center has to do some "aftercare" after the completion of the CNC machining.
1. Clean up
After the machining center completes the cutting task, it must promptly remove the chips, wipe the machine god, and use the machine tool to keep the environment clean;
2. Inspection and replacement of accessories
First of all, pay attention to check the oil wiping plate on the guide rail, if it is worn out, replace it in time. Check the state of lubricating oil and coolant. If turbidity occurs, replace it in time, and add it if the water level is below the scale.
Third, the shutdown procedure should be standardized
The power supply on the machine operation panel and the main power supply should be turned off in sequence. In the absence of special circumstances and special requirements, the principles of first zero return, manual, jog, and automatic should be followed. The machining center should also run at low speed, medium speed, and then high speed. Low-speed and medium-speed running time shall not be less than 2-3 minutes before starting to work without abnormal conditions.
Fourth, standardize operation to ensure safety
It is strictly forbidden to hit, straighten, or correct the workpiece on the chuck or at the top. The next operation must be performed after the workpiece and the tool are clamped. The insurance and safety protection devices on the machine tool must not be disassembled or moved arbitrarily by the operator.
The most efficient processing is actually safe processing. As an efficient processing equipment, the operation of the processing center when shutting down must be reasonable and standardized. This is not only the maintenance of the current completed process, but also the preparation for the next start.
