Aug 25, 2021 Leave a message

Dubai Customer Tap Endmills Ready For Shipment


Thanks for customers support for choice our taps endmills . we are ready to provide most good quality tools  for our customers . 


How do general wire taps need to be maintained on a daily basis?

1. When tapping, the end hole should be chamfered; the tap should be coaxial with the hole of the workpiece; at the beginning of tapping, axial pressure should be applied to make the tap cut in. After a few turns, there is no need to apply axial force.

2. After the calibrated part of the tap enters the screw hole, it will return 1/4 or 1/2 turn every half turn to one turn, so that the chips will be broken before tapping down; when tapping the through hole, it must be withdrawn frequently Tap for chip removal.

3. When tapping on steel workpieces, add cutting fluid. When tapping on cast iron workpieces, add a little kerosene; after using the first tap, when using the second and third taps, the hand tap must be screwed into the screw. hole.

4. When threading, the end of the workpiece should be chamfered, and the end face of the threading should be perpendicular to the axis of the workpiece; the axial pressure should be applied at the beginning of the threading, and the rotating pressure should be correspondingly larger; when the threading is cutting the thread on the workpiece, Don't put more pressure on it.

5. In order to break the chips and discharge them in time when threading, the teeth should be turned frequently.

6. The workpiece should be firmly fixed on the clamps and fixtures; when the tapping tap is broken, do not touch the broken place with your hands, use a clamp or punch to remove it, and wear protective glasses when the wire is broken.


Send Inquiry

whatsapp

skype

E-mail

Inquiry