Dec 04, 2023 Leave a message

The Mold May Seem Simple in Shape, But Its Structure Is Actually Quite Complex.

 

Product: Headphone clip

Material: PC

Number of holes: 1X1

Product features: simple shape and complex structure to minimize wire clamping.

picture

1. First, perform slope analysis. It can be seen from Figure 1 that this mold has 4 undercuts.

picture

figure 1

2. It can be seen from Figure 2 that this set of molds also has 3 undercuts, totaling 7 undercuts in total.

picture

figure 2

3. Through thickness analysis, it can be concluded that the basic wall thickness of the product is 2.3mm.

picture

image 3

4. Establish undercut 1 and undercut 6 and make two small sliders (slider 1 and slider 2).

picture

Figure 4

5. Undercut 2 and undercut 5 are inside the product, so they can only be made into an inner slider, a mold base plus a supporting plate, and secondary ejection.

picture

Figure 5

6. Confirm undercut 4 and undercut 7 and use slider 5 and slider 6 to remove the mold.

picture

Figure 6

7. There is no undercut at position 7 of the slider. The slider is made to meet the need to reduce wire clamping.

picture

Figure 7

8. The 3 undercuts are ejected using a sloped top. Since there are sliders all around, the clamping force is small, and the ejection is borne by this sloped top.

picture

Figure 8

Let's take a look at this set of molds as a whole and draw the following conclusions: This is a very simple product, but the structure is not simple. It uses a total of 7 sliders and a sloped top.

picture

Send Inquiry

whatsapp

skype

E-mail

Inquiry