Dec 19, 2023 Leave a message

There Are Undercuts All Around. Is It A Sloping Top Or A Slider?

 

When taking out the mold, push the inclined top upward in the diagonal direction (angle 90°). After the inclined top comes out of the mold, the distance between the inclined top and the product buckle should be

0.5MM or above can ensure that the product will not buckle to the inclined roof when it comes out of the mold;

What is the mold slider: It is an important part to complete the side core pulling. It is used in conjunction with the guide chute and is driven by an inclined guide post to perform side core pulling;

In the plastic mold, the mold opening action of the molding is used to cause the diagonal support tip and the slider to have a relative movement tendency, so that the slider moves in two forms of movement along the mold opening direction and the horizontal direction to break away from the undercut. As shown below:

picture

picture


1. Analysis and design
When encountering this kind of product, we will first consider whether it is possible to make a sloped roof, but after analysis, the undercuts at the four corners of the sloped roof cannot be detached (the sloped roof is made in the direction of the arrow)

picture

2. Plan
The inclined roof cannot be fully detached and the buckle cannot be completely released. We can only consider whether it can be designed using the inclined roof + inner slider. As shown in the picture below, the green part is the inner slider and the pink part is the sloped top.

Image] [image

3. Operating principle:
The front and rear molds are partially opened, and the slope of the shovel drives the inner slider to move inward. It first breaks away from the undercuts at the four corners of the product, and then the four inclined ejector ejects the product. At the same time, it breaks away from the undercuts, takes out the product, and closes the mold. Next production.

Send Inquiry

whatsapp

skype

E-mail

Inquiry